Renault Clio: Cabin filter: Removal - Refitting

LEFT-HAND DRIVE

Note: The cabin filter is located in the passenger side A-pillar.

REMOVAL

I - REMOVAL PREPARATION OPERATION

SCHOOL VEHICLE

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the cabin filter. Remove the cabin filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION

SCHOOL VEHICLE

RIGHT-HAND DRIVE

REMOVAL

OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

Note: Foreign bodies (leaves, insects etc.) are likely to accumulate in the passenger compartment filter.

Remove the filter with care so as to prevent foreign bodies getting into the evaporator.

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Cabin filter: Removal - Refitting

READ NEXT:

 Rear air distribution duct: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Lock the airbag computer using the Diagnostic tool (see Fault finding - Replacement of components) (MR 394, 88C, Airbags and pretensioners). Disconnect

 Recirculation control cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base

 Air distribution cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment),

SEE MORE:

 Clutch position sensor: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). II - OPERATION FOR REMOVAL OF PART CONCERNED R

 Front seat: Stripping - Rebuilding

WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 1 IMPORTANT Before carrying out any work on a safety or proximity system component, lock the airbag computer using the Diagnostic tool. When this function is activated all the ignition lines are disabled and the airbag warning light on the instrument pan

© 2016-2025 Copyright Renault Clio Owners Club