Renault Clio: Heating resistors: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Air Conditioning / Heating / Heating resistors: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the centre console (see Centre console: Removal - Refitting) (MR 393, 57A, Interior equipment).
- Unclip the trim at (1) and (2) at the base of the dashboard.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (3) from the heating resistors.
- Remove:
- the bolts (4) from the heater resistors,
- the heater resistors.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit:
- the heater resistors.
- the bolts (6) from the heater resistors.
- Connect the connector (5) to the heating resistors.
II - FINAL OPERATION.
- Clip on the dashboard lower trim.
- Refit the centre console (see Centre console: Removal - Refitting) (MR 393, 57A, Interior equipment).
READ NEXT:
Passenger compartment fan assembly control unit: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(80A, Battery).
Partially remove the seal (1).
Remove the side panel (2).
Remove the
Control panel: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2) at the base of t
Front side air distribution duct: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
SEE MORE:
Distribution unit: Removal - Refitting
AIR CONDITIONING
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 62A, Air conditioning, Air conditioning:
Precautions for the repair, 62A-1).
REMOVAL
I - REMOVAL PREPARATION OPERATION
Drain the refrigerant circuit using the ref
Expansion bottle: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 393, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the front bumper (see Front bumper: Removal -
Ref
© 2016-2025 Copyright Renault Clio Owners Club
