Renault Clio: Navigation: List and location of components
NAVIGATION AID 1 LEVEL or NAVIGATION AID 1
I - LIST OF COMPONENTS
The "navigation" equipment consists of:
- a navigation aerial (see 86A, Radio, Radio aerial:
Removal - Refitting, 86A-11)
NAVIGATION AID 1
- a radionavigation system (see 83C, On-board
telematics system, Radio navigation: Removal -
Refitting, 83C-3)
- a navigation screen (see 86A, Radio, Display: Removal
- Refitting, 86A-18)
NAVIGATION AID 1 LEVEL
- a "computer - navigation screen" assembly (see 83C,
On-board telematics system, Navigation computer:
Removal - Refitting, 83C-4)
- a multimedia network interface unit (see 83C, On-board
telematics system, Multimedia network interface
unit: Removal - Refitting, 83C-7)
- a remote control and its support on the centre
console
II - LOCATION OF COMPONENTS
Navigation aerial

NAVIGATION AID 1
Radio navigation system

Navigation screen

NAVIGATION AID 1 LEVEL
"Computer - navigation screen" assembly

Multimedia network interface unit

Radio navigation: Removal - Refitting
NAVIGATION AID 1

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the radio navigation system using tool (Ms.1544).
- Disconnect the radio navigation system connectors.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Connect the radio navigation system connectors.
- Refit the radio navigation system.
II - FINAL OPERATION
- Carry out the necessary operations (see MR 394
Fault finding, 83C, Navigation, Replacement of
components).
READ NEXT:
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
If the "computer - navigation screen" is being replaced,
carry out the necessary operations using the
Diagnostic tool (see Fault f
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
When replacing the multimedia network interface
unit, carry out the necessary operations using the
Diagnostic tool (see Fault find
Cruise control - speed limiter: List and location of components
CRUISE CONTROL
I - LIST OF COMPONENTS
Switch
Steering wheel switch
Brake switch
Clutch switch
II - LOCATION OF COMPONENTS
1 - Swit
SEE MORE:
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
the front wheel arch liners
D4F or F4R or K4J or K4M or M4R
WARNING
The breather must not be blocked during normal
engine operation.
The tank is vented through the fuel vapour absorber.
Fuel vapour is trapped by the active carbon contained
in the absorber as it passes through.
Fuel vapour trapped in the absorber is eliminate
© 2016-2025 Copyright Renault Clio Owners Club
