Renault Clio: Rear screen: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the tailgate trim (see Tailgate trim: Removal - Refitting)
(73A, Non-side opening elements trim),
- the rear screen wiper arm (see Rear screen wiper
arm: Removal - Refitting) (85A, Washing - Wiping),
- the rear screen wiper motor (see Rear screen wiper
motor: Removal - Refitting) (85A, Washing -
Wiping).
B85 or C85 or S85
- Remove the high level brake light (see 3rd brake
light: Removal - Refitting) (81A, Rear lighting).
- Disconnect the de-icing connectors.
REAR SPOILER
- Remove the tailgate spoiler (see 56A, Exterior
equipment, Tailgate spoiler: Removal - Refitting, 56A-3).
K85

- Remove the side seals (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85

K85

- Protect the edges of the rear screen using masking
tape.
- Cut the cement bead (see Technical Note 560A).
REFITTING
I - REFITTING PREPARATION OPERATION
- parts always to be replaced: Rear screen adjusting
shim (50,04,12,03).
- Refit the rear screen wiper motor (see Rear screen
wiper motor: Removal - Refitting) (85A, Wiping -
Washing).
- For preparation and bonding (see Technical Note
560A).
II - REFITTING OPERATION FOR PART
CONCERNED
- Bond the rear screen (this operation requires two
people).
- Equal out the clearances and shut lines.
- Remove the tabs from the stops once the adhesive
has dried.
III - FINAL OPERATION
K85
- Refit the side seals (1).
REAR SPOILER
- Refit the tailgate spoiler (see 56A, Exterior equipment,
Tailgate spoiler: Removal - Refitting, 56A-3).
B85 or C85 or S85
- the high level brake light (see 3rd brake light: Removal
- Refitting) (81A, Rear lighting).
- Connect the de-icing connectors.
- Refit the rear screen wiper arm (see Rear screen
wiper arm: Removal - Refitting) (85A, Wiping -
Washing).
- Carry out a function test.
- Refit the tailgate trim (see Tailgate trim: Removal -
Refitting) (73A, Non-side opening elements trim).
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Protect the edges of the trim with masking tape.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Note:
Fixed side trims may be removed in one of two
ways, dep
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR392, 02, Lifting equipment).
Remove:
the lower bolts (1).
the front pa
SEE MORE:
Electrical and electronic accessoriesBefore installing
this type of accessory (particularly for transmitters/receivers:
frequency bandwidth, power level, position
of the aerial, etc.), make sure it is compatible with your vehicle. You
can get advice from an authorised dealer.
K9K, and 764 or 772
IMPORTANT
Consult the safety instructions and cleanliness
advice and the operation recommendations before
carrying out any repairs (see Diesel injection:
Repair precautions).
IMPORTANT
Before carrying out any work on the injection system,
check using the Diagnostic tool :
that
© 2016-2025 Copyright Renault Clio Owners Club
