Renault Clio: Left-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
- Side air vent.
- Stalk for:
- direction indicator lights;
- exterior lights;
- front fog lights;
- rear fog lights.
- Instrument panel.
- Driver Airbag and horn location.
- Multimedia system voice control
button.
- Stalk:
- windscreen and rear screen
wash/wipe;
- trip computer and warning
system information readout.
- Centre air vents.
- Windscreen demister outlet.
- Hazard warning lights switch.
The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
- Door electric locking switch.
- Multimedia touch-screen.
- Heating or air conditioning controls.
- Passenger Airbag location.
- Side air vent.
- Storage space.
- Glovebox.
- RENAULT card reader.
- Gear lever.
- Handbrake.
- Activation/deactivation control for
ECO mode.
- Cruise control/speed limiter
control.
- Cigarette lighter/accessories
socket.
- Engine start/stop button.
- Control for adjusting steering
wheel height and reach.
- Cruise control/speed limiter
controls.
- Bonnet release control.
- Controls for:
- electric headlight beam adjustment,
- instrument panel lighting dimmer,
- activate/deactivate the parking
distance control system,
- activation/deactivation of the
function Stop and Start.
READ NEXT:
The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
Side air vent.
Passenger Airbag location.
Heating or air conditioning controls.
Multimedia touch-screen.
Wind
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT
AND COUNTRY.
Instrument panel A: lights up when
the ignition is switched on. The brightness
can be adjusted by turning
Rev counter 1
(graduations x 1000)
Speedometer 2
(km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer
sounds for approximately 10 seconds
every 40 seconds, as long
SEE MORE:
I - MAIN REFERENCE POINTS BEFORE TRIM-SETTING
1 - Front sub-frame in place
The jig crowns the front sub-frame rear mounting bolt (A).
Use this situation for a rear impact or a light frontal impact
without removal of the mechanical components.
2 - Front mechanical components removed
The jig rests
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Set up the (Mot. 582-01) (2).
Remove:
the bolts (2),
the drive plate,
tool (Mot. 582-01).
© 2016-2025 Copyright Renault Clio Owners Club
