Renault Clio: Front left-hand wiring: Connector access
I - LOCATION OF CONNECTORS

- Connection R 107 (front left-hand wiring/dashboard
wiring connection) composed of two to four connectors
depending on equipment.

- R 374 connector (front left-hand wiring/rear left-hand
wiring connection).

- Connection R 67 (front left-hand wiring/engine wiring
harness connection) composed of two to three
connectors depending on equipment.

- R 33 connector (front left-hand wiring/front bumper
wiring connection).
II - ACCESS TO CONNECTORS
IMPORTANT
Consult the safety and cleanliness advice and
operation recommendations before carrying out
any repair (see 88A, Wiring harness, Wiring:
Precautions for the repair, 88A-5).
WARNING
To prevent damaging the connectors, consult the
disconnection procedure (see Connector: Disconnection
and reconnection) (Technical Note
6015A, 88A, Wiring).
- Switch off the ignition.
- Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, 80A-1).
1 - Access to the R 107 connectors
LEFT-HAND DRIVE

- Remove the dashboard side face (1).

- Remove:
- the dashboard trim piece (2),
- the dashboard lower trim bolt (3).

- Remove:
- the dashboard lower trim bolt (4).
- the dashboard lower trim.

- Disconnect the connectors from connection R 107.
RIGHT-HAND DRIVE
- Remove the glovebox (see Glovebox: Removal -
Refitting) (MR 393, 57A, Interior equipment).

- Disconnect the connectors from connection R 107.
2 - Access to the R 374 connector
- Remove the front left-hand door sill lining (see Front
door sill lining: Removal - Refitting) (MR 393,
71A, Body internal trim).

- Disconnect the R 374 connector.
3 - Access to the R 67 connector

- Remove:
- the bolts (5) from the Protection and Switching Unit
cover,
- the Protection and Switching Unit cover.

- Disconnect the connectors from connection R 67.
4 - Access to the R 33 connector
- Remove the front section of the front left-hand wheel
arch liner (see Front wheel arch liner: Removal -
Refitting) (MR 393, 55A, Exterior protection).

- Disconnect the R 33 connector.
READ NEXT:
LEFT-HAND DRIVE
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
I - LOCATION OF CONNECTORS
R 67 connector (Engine wiring harness/front left-hand
wiring connection).
Depending on the engine, connection R 67 is composed
of three or four connectors.
K4J or K4
SEE MORE:
Rotary switch: Removal - Refitting
The rotary switch is part of the steering column control
assembly. It cannot be replaced on its own.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the steering column control assembly (see
84A, Control - Signals, Steering column switch
assembly: Removal - Re
A well-maintained vehicle will last
longer. It is therefore recommended to
maintain the exterior of the vehicle regularly.
Your vehicle has been treated with very
effective anti-corrosion products. It is
nevertheless subject to various outside
influences.
Corrosive agents in the atmospher
© 2016-2025 Copyright Renault Clio Owners Club
