Renault Clio: Gear lever/Handbrake
Gear lever
Vehicles with manual gearbox: refer to the grid on the gear lever knob 1.
Vehicles with automatic gearbox: refer to the information on the “Automatic gearbox” in Section 2.
Selecting reverse gear The reversing lights will come on as soon as reverse gear is selected with the ignition on.
Handbrake
To release: Pull the lever 3 up slightly, press button 2 and then lower the lever to the floor.
The red warning light on the instrument panel will come on if you are driving with an incorrectly released handbrake.
To apply:
Pull lever 3 upwards. Check that the
vehicle is immobilised. The warning
light 
on the instrument panel will
come on.
| An impact to the underside
of the vehicle while
manoeuvring (e.g.: striking
a post, raised kerb or
other street furniture) may result in
damage to the vehicle (e.g.: deformation
of an axle). To avoid any risk of accident, have your vehicle checked by an approved Dealer. |
| Make sure that the handbrake is fully released when driving (red indicator light off), otherwise overheating, or even damage, may occur. |
| When stationary, and depending on the slope and/or vehicle load, it may be necessary to pull up the handbrake at least two extra notches and engage a gear (1st or reverse gear) for vehicles with a manual gearbox or position P for vehicles with an automatic gearbox. |
READ NEXT:
Eco-driving
Fuel consumption is accredited in accordance
with a standard regulatory
method. Identical for all manufacturers,
this enables vehicles to be compared
with one another. Consumption
in real time de
Gear change indicator
Gear change indicator 1
To obtain optimum consumption levels,
a warning light on the instrument panel
lets you know the best time to move up
or down a gear:
move up a gear;
move down a gea
Journey record
Once the engine is switched off, you
will see “Journey record” displayed on
the screen 3, enabling you to view information
relating to your last journey.
This indicates:
average fuel
SEE MORE:
Front driveshaft gaiter, wheel side: Removal -
Refitting
M4R, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the driveshaft on the side concerned (see
29A, Driveshafts, Front right-hand driveshaft:
Removal - Refitting, 29A-9) or (see 29A,
Driveshafts, Front left-hand driveshaft: Removal
- Refitting, 29A-2).
II - OPERATION FOR REMOVAL OF
Clutch pedal switch: Removal - Refitting
JH3 or JR5 or TL4, and CRUISE CONTROL - JH3 or JR5 or TL4, and VEHICLE
WITH CARD
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the driver side dashboard lower trim clips (1),
the driver side dashboard lower trim (2).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
CRUISE CONTROL
Dis
© 2016-2025 Copyright Renault Clio Owners Club
