Renault Clio: Pressure at end of compression: Check

K9K

Renault Clio. Pressure at end of compression: Check

Renault Clio. Pressure at end of compression: Check

Renault Clio. Pressure at end of compression: Check

Renault Clio. Pressure at end of compression: Check

Note: The pressure value after compression must be at least 18 bar.

D4F

Renault Clio. Pressure at end of compression: Check

CHECK

I - PREPARATION OPERATION FOR CHECK

Note: Use a petrol compression gauge compatible with the special tools.

The petrol compression gauge must be equipped with a universal end piece (rubber), or a gaz 1/4 thread bolt.

Renault Clio. Pressure at end of compression: Check

II - TEST OPERATION

Note: It is necessary to wait for at least 10 seconds before starting the engine each time (the starter will not run due to its thermal protection).

III - FINAL OPERATION

Note: If the engine does not start, run command VP037: STOP FUEL SUPPLY INHIBITION using the Diagnostic tool or switch off the ignition and wait 1 min before starting the engine again.

K4M

Renault Clio. Pressure at end of compression: Check

CHECK

I - PREPARATION OPERATION FOR CHECK

Renault Clio. Pressure at end of compression: Check

II - TEST OPERATION

Note: It is necessary to wait for at least 10 seconds before starting the engine each time (the starter will not run due to its thermal protection).

III - FINAL OPERATION

READ NEXT:

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

 Crankshaft accessories pulley: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the fron

 Timing belt: Removal - Refitting

SEE MORE:

 Technical specifications

The Renault Clio IV, produced from 2014 to 2019, offers a range of technical specifications that contribute to its performance and versatility. It is available with gasoline and diesel engine options, including 0.9-liter, 1.2-liter, and 1.6-liter engines, with power outputs ranging from approximatel

 Rear Lower Structure

Luggage retaining cross member: Removal - Refitting I - REMOVAL 1 - REMOVAL PREPARATION OPERATION Remove the luggage compartment carpet. Remove the rear bench seat. Remove the protective carpet of the luggage retaining cross member. 2 - OPERATION FOR REMOVAL OF PART CONCERNED Remove: th

© 2016-2025 Copyright Renault Clio Owners Club