Renault Clio: Rear end panel lining: Removal - Refitting

REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85

- Remove the luggage compartment carpet.
K85

- Remove the luggage compartment raised floor (1).

- Remove the luggage compartment carpet (2).
- Partially remove the luggage compartment seal.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85

- Remove the clips (3) using a flat-blade screwdriver.

- Remove the towing ring bolts (4).

- Unclip the rear end panel trim.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the rear end panel lining,
- the towing rings.
- Torque tighten the towing ring bolts (21 Nm).
B85 or C85 or S85

II - FINAL OPERATION.
B85 or C85 or S85
- Refit the luggage compartment carpet.
K85
- Remove:
- the luggage compartment carpet (2),
- the luggage compartment raised floor (1).
- Refit the luggage compartment seal.
READ NEXT:
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front speaker (see Front speakers:
Removal - Refitting) (MR 392, 86A, Radio).
Unclip the door mirror trim piece (1).
II - OPERATION FOR REM
SEE MORE:
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the engine undertray,
DP0 or JH3 or JR5 or TL4
WARNING
A gearbox oil leak at the driveshaft may destroy it.
WARNING
Always replace seals whenever the driveshaft is
removed.
WARNING
Grease the base of the bearing using BR 2 +
grease to prevent the bearing from sticking.
Make sure that the O-ring is correctly positioned i
© 2016-2025 Copyright Renault Clio Owners Club
