Renault Clio: Battery for remote door locking control: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
VEHICLE WITH KEY


- Open the key with a coin (2).
VEHICLE WITH CARD

- Remove the mechanical insert (3).
REFITTING
I - REFITTING PREPARATION OPERATION
WARNING
To ensure that the remote control operates correctly,
take care not to damage the battery contacts.
Only handle the new battery with dry, grease-free
hands or wearing clean gloves to avoid any risk
of dirt and oxidation on the battery.
II - REFITTING OPERATION FOR PART
CONCERNED
VEHICLE WITH KEY

- Replace the battery (4) using a flat-blade screwdriver.
VEHICLE WITH CARD

III - FINAL OPERATION.
VEHICLE WITH KEY
- Close the key.
- Tighten the bolt (1).
VEHICLE WITH CARD
- Refit the mechanical insert (6).
READ NEXT:
VEHICLE WITH CARD
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2
Clock: Before/after repair procedure
SETTING THE CLOCK
WITHOUT NAVIGATION AID, and RADIO NO. 01
or RADIO NO. 02 or RADIO NO. 03 or RADIO NO.
04 or RADIO NO. 05 or RADIO NO. 06 or RADIO
NO. 07 or RADIO
SEE MORE:
A wheel size larger than 15” cannot
be installed under the vehicle.
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its own, unwind it again as follows:
pull the handle to unwind the cable;
press the button located u
RIGHT-HAND DRIVE
There is no "RENAULT" tool to check the braking assistance
circuit.
Use a vacuum pump fitted with couplings, part numbers
7701349942 and 7700105874 with hose part
number 8200027352 or 8200376245.
CHECK
I - CHECKING THE SEALS
When checking the brake servo seal, ensure that there
© 2016-2025 Copyright Renault Clio Owners Club
