Renault Clio: Cruise Control
Cruise control - speed limiter: List and location of components
CRUISE CONTROL
I - LIST OF COMPONENTS
- Switch
- Steering wheel switch
- Brake switch
- Clutch switch
II - LOCATION OF COMPONENTS
1 - Switch

2 - Steering wheel switch

3 - Brake switch

4 - Clutch switch

Switch: Removal - Refitting
CRUISE CONTROL

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Unclip the switch panel (1) using the (Car. 1363).
- Disconnect the connectors.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the switch by pressing on the clips (2).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the switch on the switch panel.
- Connect the connectors.
II - FINAL OPERATION.
- Clip the switch panel onto the lower cover.
READ NEXT:
Rotary switch: Removal - Refitting
The rotary switch is part of the steering column control
assembly. It cannot be replaced on its own.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the steering
Wiping and washing: List and location of components
Passenger compartment
fuse and relay box
Protection and Switching
Unit
Power supply fuse board
UCH
Rain sensor
Wiper switch
Windscreen wip
Radio: List and location of components
I - LIST OF COMPONENTS
The radio system comprises:
a radio control satellite (see 86A, Radio, Radio control
satellite: Removal - Refitting, 86A-19)
a radio a
SEE MORE:
A-pillar: General description
C85
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip the blanking cover (1).
Remove the bolt.
Remove the side mounted indicator (2) using a small
flat screwdriver.
Disconnect the power supply connector.
II - REMOVAL OPERATION FOR PART
CONCERNED
Slide the door rubbing strip towards the rear
© 2016-2025 Copyright Renault Clio Owners Club
