Renault Clio: Engine cooling: Parts and consumables for the repair

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Cooling / Engine cooling: Parts and consumables for the repair

INGREDIENT

Coolant GLACEOL RX (TYPE D)

Note: Ready-to-use coolant or antifreeze must be diluted with distilled water in accordance with the guidelines marked on the container.

Engine cooling: Precautions for the repair

IMPORTANT

The circuits are designed to be pressurized, so be careful at high temperatures (risk of serious burns).

Never remove the cap from the expansion bottle while the engine is hot.

Take care when carrying out a repair under the bonnet, as the radiator fan(s) may start to operate without warning.

Do not open the bleed valve(s) while the engine is running.

Only use recommended coolants: GLACEOL RX (TYPE D).

WARNING

WARNING

Take care not to damage the cooling unit fins (radiator, condenser, etc.) during handling. When carrying out a repair that requires a complete circuit drain, it is essential to flush the circuit with clean water, blow compressed air through the circuit to eliminate water, fill and drain the circuit and then " measure the effective protection " . The parameters to be observed are:

READ NEXT:

 Engine cooling system: Check

IMPORTANT When working in the engine compartment, take care as the radiator fan(s) may start up unexpectedly (risk of being cut). To avoid any risk of serious burns when the engine is hot: do not

 Engine cooling system: Operating diagram

D4F D4F, and 740 or 742 or 764 Engine Cooling radiator heater matrix Expansion bottle Water pump Thermostat Bleed screws 5 mm restriction 10 mm restriction Note: The rating of the expansio

 Cooling system: Draining - Refilling

IMPORTANT The circuits are designed to be pressurised, so be careful at high temperatures (risk of serious burns). Do not remove the cap from the expansion bottle while the engine is hot. Take care

SEE MORE:

 Brake servo: Check

RIGHT-HAND DRIVE There is no "RENAULT" tool to check the braking assistance circuit. Use a vacuum pump fitted with couplings, part numbers 7701349942 and 7700105874 with hose part number 8200027352 or 8200376245. CHECK I - CHECKING THE SEALS When checking the brake servo seal, ensure that there

 Interior rear-view mirror: Removal - Refitting

REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Unclip: the upper cover, the lower cover. Note: When removing the rear view mirror, be careful not to damage the rain sensor nearby. Disconnect the connectors. Remove the rear view mirror. REFITTING REFITTING OPERATION FOR PART CONCERN

© 2016-2025 Copyright Renault Clio Owners Club