Renault Clio: Front end lower cross member: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehicle.
These special notes are specified if necessary
in other parts of the sub-section dealing with the
component.
Note:
For a detailed description of a particular connection,
see MR 400, 40A, General Information.
DESIGN OF THE STRUCTURAL COMPONENT

A special feature of this part is that it is bolted to the
ends of the front side members via the radiator cross
member mounting support.
Front impact cross member: Removal - Refitting

I - REMOVAL
1 - REMOVAL PREPARATION OPERATION
- Remove the front bumper (see Front bumper: Removal - Refitting).
- Remove the headlights (see ) (see Xenon headlight: Removal - Refitting).
2 - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove side mounting bolts (1) (three on either
side).
II - REFITTING
1 - REFITTING OPERATION FOR PART
CONCERNED
- Refit the side mounting bolts.
WARNING
The cross member contributes to the structural
rigidity of the engine compartment. For this reason,
the tightening torque must be observed following
any operation.
- Torque tighten the side mounting bolts (1) (44
Nm).
2 - FINAL OPERATION
- Refit the headlights (see ) (see Xenon headlight: Removal - Refitting).
- Refit the front bumper (see Front bumper: Removal - Refitting).
READ NEXT:
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
ther
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Position for use
Raise the headrest as far as possible to
use it in the high position. Check that it
is correctly locked.
Storage position
Press button A and lower the headrest
completely.
When the headrest is set at the
lowest position, this is for storage
only. It should not be in t
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 35A-1),
the engine undertray bolts,
the engine undertray,
the fr
© 2016-2025 Copyright Renault Clio Owners Club
