Renault Clio: Towing
Before towing, unlock the steering column: with the clutch depressed, engage first gear (lever in position N or R for vehicles with automatic gearboxes), insert the RENAULT card in the card reader, then press the engine start button for two seconds.
Reposition the lever to neutral (position N for vehicles fitted with an automatic gearbox).
The column is unlocked, the accessory functions are supplied: the vehicle lights can be used (indicators, brake lights etc.). At night the vehicle must have its lights on.
Once you have finished towing, press the engine start button twice (risk of running down the battery).
| Do not remove the RENAULT card from the reader when the vehicle is being towed. |
The speed specified by current legislation for towing must always be observed.
If your vehicle is the towing vehicle, do not exceed the maximum towing weight for your vehicle (refer to the information on “Weights” in Section 6).
READ NEXT:
Towing a vehicle with an automatic gearbox
With the engine switched off, the transmission
is no longer lubricated. It is
preferable to tow this type of vehicle on
a trailer or tow it with the front wheels
off the ground.
Under exception
Access to towing points
Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tight
Operating faults
The following advice will enable you to carry out quick, temporary repairs.
For safety reasons you should always contact
an approved Dealer as soon as possible.
Using the RENAULT card
SEE MORE:
Filler neck: Removal - Refitting
D4F or F4R or K4J or K4M or K9K or M4R
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operation.
IMPORTANT
Wear latex gloves during the operation.
WARNING
To prevent impurities from ente
Electric steering column lock: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
to unlock the steering column lock (see Fault finding
- Replacement of components) (MR 394, 88C,
Airbags and seat belt pretensioners).
Unclip trim (1).
Unclip:
the plasti-rivet (2),
the bol
