Renault Clio: Navigation: List and location of components
NAVIGATION AID 1 LEVEL or NAVIGATION AID 1
I - LIST OF COMPONENTS
The "navigation" equipment consists of:
- a navigation aerial (see 86A, Radio, Radio aerial:
Removal - Refitting, 86A-11)
NAVIGATION AID 1
- a radionavigation system (see 83C, On-board
telematics system, Radio navigation: Removal -
Refitting, 83C-3)
- a navigation screen (see 86A, Radio, Display: Removal
- Refitting, 86A-18)
NAVIGATION AID 1 LEVEL
- a "computer - navigation screen" assembly (see 83C,
On-board telematics system, Navigation computer:
Removal - Refitting, 83C-4)
- a multimedia network interface unit (see 83C, On-board
telematics system, Multimedia network interface
unit: Removal - Refitting, 83C-7)
- a remote control and its support on the centre
console
II - LOCATION OF COMPONENTS
Navigation aerial

NAVIGATION AID 1
Radio navigation system

Navigation screen

NAVIGATION AID 1 LEVEL
"Computer - navigation screen" assembly

Multimedia network interface unit

Radio navigation: Removal - Refitting
NAVIGATION AID 1

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the radio navigation system using tool (Ms.1544).
- Disconnect the radio navigation system connectors.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Connect the radio navigation system connectors.
- Refit the radio navigation system.
II - FINAL OPERATION
- Carry out the necessary operations (see MR 394
Fault finding, 83C, Navigation, Replacement of
components).
READ NEXT:
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
If the "computer - navigation screen" is being replaced,
carry out the necessary operations using the
Diagnostic tool (see Fault f
NAVIGATION AID 1 LEVEL
REMOVAL
I - REMOVAL PREPARATION OPERATION
When replacing the multimedia network interface
unit, carry out the necessary operations using the
Diagnostic tool (see Fault find
Cruise control - speed limiter: List and location of components
CRUISE CONTROL
I - LIST OF COMPONENTS
Switch
Steering wheel switch
Brake switch
Clutch switch
II - LOCATION OF COMPONENTS
1 - Swit
SEE MORE:
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the rear wheel in question (see 35A, Wheels and
tyres, Wheel: Removal - Refitting, 35A-1),
the rear brake pads (see 33A,
I - MAIN REFERENCE POINTS BEFORE TRIM-SETTING
1 - Front sub-frame in place
The jig crowns the front sub-frame rear mounting bolt (A).
Use this situation for a rear impact or a light frontal impact
without removal of the mechanical components.
2 - Front mechanical components removed
The jig rests
© 2016-2025 Copyright Renault Clio Owners Club
