Renault Clio: Manual gearbox: Identification
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox / Manual gearbox: Identification
JA3 or JA5 or JH3 or JR5
K4J / K4M / K9K / D4F engines are fitted with type JH and JR manual gearboxes.
A marking (1) on the gearbox casing indicates:
- Gearbox type
- Gearbox suffix
- Production plant
- Production number
K9K, and TL4 - F4R, and 830, and TL4
- Identification plate
- Engraving
- Gearbox type
- Gearbox suffix
- Production plant
- Production number
Manual gearbox oils: Draining - Filling
JH3 or JR5
Capacity (in litres)
DRAINING
- Remove:
- the engine undertray mounting bolts,
- the engine undertray.
JH3
- Remove the drain plug (1).
JR5
- Remove the drain plug (2).
FILLING
- It is essential to replace the drain plug seal.
- Refit the drain plug.
JH3
- Remove the filler cap (3).
JR5
- Remove the filler cap (4).
- Fill up to the level of the opening with oil recommended by the manufacturer (see Manual gearbox oil: Specifications) (Technical Note 6012A, 04, Lubricants).
- Refit the filler cap.
- Refit:
- the engine undertray,
- the engine undertray mounting bolts.
Manual gearbox: Specifications
JA3 or JA5 or JH3 or JR5
GEAR RATIOS
TL4
GEAR RATIOS
READ NEXT:
Manual gearbox: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
IMPORTANT
During this operation, secure the vehicle to the
lift wi
Input shaft lip seal: Removal - Refitting
JH3 or JR5
Replace the lip seal after opening the gearbox (see
Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the gearbox (see 21A, Manual gearb
Differential output seal: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Batter
SEE MORE:
Brake servo non-return valve: Removal - Refitting
LEFT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M or K9K
Remove the engine cover.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Disconnect the non-return valve (1) at the servo.
Pull and turn the non-return valve to release it from
the rubber sealing washer.
K9K
Disconn
Access to towing points
Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tightening it using the wheelbrace or,
depending on the vehicle, the lever.
Only use the towing eye 3
© 2016-2025 Copyright Renault Clio Owners Club
