Renault Clio: Opening Element Sealing
Door sealing film: Removal - Refitting
REMOVAL
Note:
The sealing film can only be used once; it is destroyed
when it is removed.
It is essential to replace the film with a new one
each time it is removed.
REMOVING THE SEALING FILM
- Remove the door trim( (see Front side door trim:
Removal - Refitting) (MR 393, 72A, Side opening
elements trim) or( (see Rear side door trim: Removal
- Refitting) (MR 393, 72A, Side opening elements
trim).

- Unclip the interior handle mounting (if the vehicle is
fitted with one) using an unclipping tool.
1 - First procedure
- Strip off the sealing film using a hot air gun set to approximately
100
READ NEXT:
Front side door glass run channel: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the door trim( (see Front side door trim: Removal
- Refitting) (MR 393, 72A, Side opening
Bonnet soundproofing: Removal - Refitting
REMOVAL
REMOVAL OPERATION FOR PART CONCERNED
Remove clips (1) using a pair of unclipping pliers.
Remove the bonnet soundproofing.
REFITTING
REFITTING OPE
Clio IV (2014-2019) offers a range of trim levels and upholstery options to suit individual preferences and style. The trim levels may vary, offering different levels of features and equipment. The up
SEE MORE:
Sill panel: Description
B85 or K85
To replace this part, also order the expanding inserts
corresponding to each of the following cases.
The options for replacing this part are as follows:
partial replacement of the front end section, order the
exterior A-pillar insert (see 40A, General informat
DP0 or JH3 or JR5 or TL4
Deflector
Propeller shaft
Driveshaft yoke sleeve
Spider
RC gaiter
Tightening clip
Lock ring
Tightening ring
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Di
© 2016-2025 Copyright Renault Clio Owners Club
