Renault Clio: High level brake light bulb: Removal - Refitting
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the tailgate spoiler (see Tailgate spoiler: Removal - Refitting),
- the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, 81A- 10).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove:
- the bulb holder by pressing on the clips (1),
- the bulbs.
Note:
When replacing bulbs, use approved W5W bulbs.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Clip:
- the bulbs into the bulb holder,
- the bulb holder onto the high-level brake light.
II - FINAL OPERATION.
- Refit:
- the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, 81A- 10),
- the tailgate spoiler (see Tailgate spoiler: Removal - Refitting).
B85 or C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the high level brake light (see 81A, Rear
lighting, 3rd brake light: Removal - Refitting, 81A-10).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the bulb (1) from the bulb holder.
Note:
When replacing the bulb, use an approved
W16W bulb.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the bulb in the bulb holder.
II - FINAL OPERATION.
- Refit the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, 81A-10).
READ NEXT:
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1
Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
Fuses: List and location of components
Passenger compartment fuse and
relay box
Consumer cut-out fuse
Additional relay/fuse box
Battery protection fuses
Protection and switching unit
Power sup
SEE MORE:
D4F, and JA3
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydr
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR392, 80A, Battery).
Remove:
the air filter box (see 1
© 2016-2025 Copyright Renault Clio Owners Club
