Renault Clio: Rear view mirrors
Door mirrors with electrical adjustment
With the ignition on, turn button 1:
- position C to adjust the left-hand door mirror;
- position E to adjust the right-hand door mirror;
D is the inactive position.
| For safety reasons, carry out any adjustments when the vehicle is not being driven. |
Heated door mirrors
With the engine running, mirror deicing is activated simultaneously with rear screen de-icing/demisting.
Folding door mirrors (depending on vehicle)
Move button 1 to position F: the door mirrors fold away. To reset them for driving, return to position C, D or E.
If you manually fold the door mirrors, before setting them to the driving position (C, D, E), you must position control 1 to F
| The driver’s door mirror
may have two clearly defined
zones. Zone B shows
what can normally be seen
in an ordinary rear view mirror. Zone A increases rear side visibility. Objects in zone A look much further away than they really are. |
Interior rear view mirror
Its position can be adjusted.
Rear-view mirror with lever 2
For night driving, to avoid being dazzled by the headlights of the car behind you, flip the small lever 2 located behind the rear view mirror.
Rear view mirror without lever 2
The rear view mirror darkens automatically at night if you are being followed by a vehicle with its lights on.
READ NEXT:
Exterior lighting and signals
Side lights
Turn the ring 2 until the symbol
is opposite mark 3.
An indicator light on the instrument
panel will come on.
Daytime running lights function
(front lights only)
Dependin
Audible and visual signals
Horn
Press steering wheel boss A.
Headlight flasher
Pull stalk 1 towards you to flash the
headlights.
Direction indicators
Move stalk 1 parallel to the steering
wheel and in the direction y
Headlight adjustment
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
Turn control A downwards to lower the
headlights and upwards to raise the
SEE MORE:
Windscreen pillar trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the top of the pillar trim at (2).
remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
Check the condition of the clips (3
Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the
recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when
cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted
