Renault Clio: Rear wheel arch trim: Removal - Refitting

Renault Clio. Rear wheel arch trim: Removal - Refitting

B85 or C85

IMPORTANT

Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see Airbag and pretensioners: Precautions for the repair) (88C, Airbags and pretensioners).

IMPORTANT

To avoid any risk of triggering when working on or near a pyrotechnic component (airbags or pretensioners), lock the airbag computer using the diagnostic tool.

When this function is activated, all the trigger lines are inhibited and the airbag warning light on the instrument panel lights up continuously (ignition on).

IMPORTANT

Never handle the pyrotechnic systems (pretensioners or airbags) near to a source of heat or naked flame - they may be triggered.

REMOVAL

I - REMOVAL PREPARATION OPERATION

B85 or C85

 

B85 or K85

C85

B85 or C85

K85

II - OPERATION FOR REMOVAL OF PART CONCERNED

K85

Renault Clio. Rear wheel arch trim: Removal - Refitting

 

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

K85

B85 or C85

C85

B85 or K85

 

B85 or C85

READ NEXT:

 Windscreen pillar trim: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove the seal (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Unclip the top of the pillar trim at (2). remove the pillar trim by pul

 B-pillar upper trim: Removal - Refitting

C85 REMOVAL REMOVAL PREPARATION OPERATION Remove: the complete rear bench seat, the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32).

 B-pillar trim: Removal - Refitting

B85 REMOVAL I - REMOVAL PREPARATION OPERATION Move the seats fully forward. Partially remove the frame seals (1). Partially unclip the front and rear door sill trims. II - REMOVAL OF PART CONCE

SEE MORE:

 Exhaust manifold: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitting) (MR392, 80A, Battery). Remove: the air filter box (see 1

 Clutch circuit: Removal - Refitting

JH3 or JR5 Note: Each time an operation is carried out on the hydraulic clutch system, bleed the circuit: between the reservoir and the bleed hole, between the bleed hole and the clutch release bearing. REMOVAL I - REMOVAL PREPARATION OPERATION K4J or K4M Remove the resonator.   Remov

© 2016-2025 Copyright Renault Clio Owners Club