Renault Clio: Car Phone
Car phone: List and location of components
CAR PHONE PRE-EQUIPMENT or HANDS-FREE TELEPHONE KIT
I - LIST OF COMPONENTS
The " car phone " consists of:
- a telephone aerial
- a computer
- a "hands-free" microphone
- a telephone control on the steering wheel
II - LOCATION OF COMPONENTS
Telephone aerial
To remove the telephone aerial (see 86A, Radio, Radio aerial: Removal - Refitting, 86A-11).
Computer
"Hands-free" microphone
Telephone control at steering wheel
To remove the steering wheel car phone control (see 86A, Radio, Radio control satellite: Removal - Refitting, 86A-19).
Computer: Removal - Refitting
CAR PHONE PRE-EQUIPMENT or HANDS-FREE TELEPHONE KIT
Note: The computer is fitted behind the dashboard centre front panel under the radio.
REMOVAL
REMOVAL PREPARATION OPERATION
- Disconnect the battery (see Battery: Removal - Refitting).
- Remove the dashboard centre front panel (see Centre front panel: Removal - Refitting)
- Remove the computer (1).
- Disconnect the computer connectors (2).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Connect the computer connectors.
- Refit the computer.
II - FINAL OPERATION.
- Refit the dashboard centre front panel (see Centre front panel: Removal - Refitting)
- Connect the battery (see Battery: Removal - Refitting).
- If replacing the computer, carry out the necessary operations using the Diagnostic tool (see Fault finding - Replacement of components) (86B, Car phone).
"Hands-free" microphone: Removal - Refitting
CAR PHONE PRE-EQUIPMENT or HANDS-FREE TELEPHONE KIT
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).
- Remove the computer (see 86B, Car phone, Computer: Removal - Refitting, 86B-3).
- Unclip the dashboard side panel on the passenger side.
- Unclip the A-pillar trim on the passenger side (see Windscreen pillar trim: Removal - Refitting).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the "hands-free" microphone wire from the A-pillar clips (1).
- Remove the "hands-free" microphone wire (2) from the dashboard side panel.
- Remove the "hands-free" microphone (3) from the headlining.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the "hands-free" microphone with its wire as shown in the diagram above.
- Connect the "hands-free" microphone connector to the computer.
II - FINAL OPERATION.
- Clip:
- the A-pillar trim (see Windscreen pillar trim: Removal - Refitting),
- the dashboard side panel.
- Refit the computer (see 86B, Car phone, Computer: Removal - Refitting, 86B-3).
- Connect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).
READ NEXT:
Passenger Compartment Connection Unit
UCH: Removal - Refitting
RIGHT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
If replacing the UCH, carry out the necessary programming
using the Diagnostic tool. (see Fault
finding - Repla
Opening Element Management
Opening elements management: List and location of components
UCH
Renault card (simple or hands-free)
Key equipped with remote control
locking
Locking - unlocking motor
Specific reception receiv
Electric Windows - Sunroof
Electric window: List and location of components
ELECTRIC FRONT WINDOW or ONE-TOUCH ELECTRIC FRONT WINDOW or PASSENGER
ELECTRIC ONETOUCH
WINDOW CONTROL, and ELECTRIC REAR WINDOW
UCH
Driver's windo
SEE MORE:
Five door and estate versions
Reversing lights and rear fog
lights 12
Open the boot lid.
Unclip cover 13 and remove it.
Turn bulb holder 14 fully anticlockwise
and change the bulb.
To reassemble, proceed in the reverse
order to removal.
When the bulb has been changed,
make sure you refit the cover 13 cor
Headlight: Removal - Refitting
DISCHARGE LAMPS, and DOCUMENTATION
PHASE 1
IMPORTANT
To prevent eye injuries:
do not look at a xenon bulb when lit (voltage
when lit 20000 V),
do not light a bulb which has not been fitted into
its headlight.
IMPORTANT
To prevent burns, wait until the " computers -
power unit " assemblies are
