Renault Clio: Drive plate: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly / Drive plate: Removal -
Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the gearbox (see Automatic gearbox: Removal - Refitting).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Set up the (Mot. 582-01) (2).
- Remove:
- the bolts (2),
- the drive plate,
- tool (Mot. 582-01).
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).
II - REFITTING OPERATION FOR PART CONCERNED
- Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
- Apply LOCTITE FRENBLOC to the bolt threads.
- Tighten the bolts on the drive plate.
- Torque and angle tighten the drive plate bolts (55
Nm + 50
READ NEXT:
Pressure at end of
compression: Check
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid val
Accessories belt: Removal -
Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
SEE MORE:
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
IMPORTANT
During this operation, secure the vehicle to the
lift with a strap to prevent it from becoming unbalanced.
To fit the strap to the v
Mixing motor: Removal - Refitting
LEFT-HAND DRIVE, and CLIMATE CONTROL
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2) at the base of the dashboard.
Partially remove seal (3).
Remove the sid
© 2016-2025 Copyright Renault Clio Owners Club
