Renault Clio: Engine wiring: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness / Engine wiring: Removal - Refitting
READ NEXT:
K4J or K4M
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To preve
K9K
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To preve
D4F, and 740 or 764
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To preve
SEE MORE:
High pressure pump leak flow: Check
K9K, and 764 or 772
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Disconnect the inlet pressure sensor (1).
Remove:
the air duct (2) between the air filter and the intercooler,
the air duct (3) between the intercooler and the turbocharger.
Un
Turbocharging: Precautions for the repair
D4F or K9K
I - TURBOCHARGER: GENERAL INSTRUCTIONS
For the turbocharging pressure regulator check (see
Fault finding - Tests) (Technical Note 3419A, 12B,
Turbocharging).
WARNING
The turbocharger pressure regulator rod must not
be adjusted.
II - TURBOCHARGER CIRCUIT DIAGRAM
Air filter unit
Air fl
© 2016-2025 Copyright Renault Clio Owners Club
