Renault Clio: Reverse gear switch: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox / Reverse gear switch: Removal - Refitting
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the battery (see Battery: Removal - Refitting) (80A, Battery),
- the battery tray (see Battery tray: Removal - Refitting) (80A, Battery).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the reverse gear switch.
- Remove the reverse gear switch using the socket for removing/refitting the reverse gear switch (Bvi.1934) (2).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the reverse gear switch.
- Tighten the reverse gear switch using the socket for removing/refitting the reverse gear switch (Bvi.1934).
- Connect the reverse gear switch connector.
II - FINAL OPERATION
- Refit:
- the battery tray (see Battery tray: Removal - Refitting) (80A, Battery),
- the battery (see Battery: Removal - Refitting) (80A, Battery).
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).
- Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the reverse gear switch.
- Remove the reverse gear switch (2) using the (Bvi.1934).
Note: Seal the housing of the reverse gear switch while replacing the part.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Apply some SILICONE ADHESIVE SEALANT (see Vehicle: Parts and consumables for the repair) (04B, Consumables - Products) to the threading of the reverse gear switch.
- Refit the reverse gear switch using the (Bvi. 1934).
- Torque tighten the reverse gear switch (23 N.m).
- Connect the reverse gear switch connector.
II - FINAL OPERATION
- Fill the gearbox (see 21A, Manual gearbox, Manual gearbox oils: Draining - Filling, 21A-3).
- Refit the engine undertray.
READ NEXT:
Sequential gearbox: Precautions for the repair
D4F or K9K, and JA3 or JA5
I - SEQUENTIAL GEARBOX
WARNING
If any operation is carried out on the electro-hydraulic
unit, it is essential to clean the unit using a cleaning
product and compressed air.
Pump assembly reservoir: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, ru
SEE MORE:
Complete front seat: Removal - Refitting
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 1
IMPORTANT
Before carrying out any work on a safety or proximity
system component, lock the airbag computer
using the Diagnostic tool. When this function is
activated, all the trigger lines are disabled and the
airbag instrument panel warning light is c
Centre console: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the trim (1).
Unclip the gear lever trim.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the bolts (2).
Push the seats forward as far as possible.
Remove the bolts (3).
Take out the centre console (4).
III - REFITTING OPERATION
© 2016-2025 Copyright Renault Clio Owners Club
