Renault Clio: Input shaft lip seal: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox / Input shaft lip seal: Removal - Refitting
JH3 or JR5
- Replace the lip seal after opening the gearbox (see Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A-12),
- the clutch thrust bearing (see 20A, Clutch, Clutch thrust bearing: Removal - Refitting, 20A- 11).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Drill a hole in the seal, using a 2.5 mm drill bit.
WARNING
Do not scratch the shaft or mating face.
- Fit a bolt in seal (1).
- Extract the seal (1) using pliers.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Fit a new seal with its protector using the (Bvi.1601).
- Remove the protector.
II - FINAL OPERATION
- Refit:
- the clutch thrust bearing (see 20A, Clutch, Clutch thrust bearing: Removal - Refitting, 20A- 11).
- the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A-12).
READ NEXT:
Differential output seal: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Batter
Reverse gear switch: Removal - Refitting
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting)
(80A, Battery),
the battery tray (see Battery tray: Removal - Refitting)
(80A, Battery).
SEE MORE:
Front side member, centre section: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
Exhaust gas recirculation solenoid valve: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the engine undertray,
© 2016-2025 Copyright Renault Clio Owners Club
