Renault Clio: Parking sensor
Operating principle
Ultrasonic detectors, installed in the rear bumper (depending on the vehicle), measure the distance between the vehicle and an obstacle whilst reversing.
This measurement is indicated by beeps which become more frequent the closer you come to the obstacle, until they become a continuous beep when the vehicle is approximately 30 centimetres from the obstacle.
NB: make sure that the ultrasonic sensors are not obscured (by dirt, mud, snow, etc.).
NB: depending on the vehicle, screen 1 shows the vehicle surroundings alongside the beeps.
Operation
When reverse gear is selected, most objects which are less than approximately 1.20 metres from the rear of the vehicle are detected, a beep sounds and, depending on the vehicle, display 1 lights up.
| This function is an additional aid that indicates the distance
between the
vehicle and an obstacle whilst reversing, using sound signals. Under no circumstances should it replace the driver’s care or responsibility whilst reversing. The driver should always look out for sudden hazards during driving: always ensure that there are no moving obstacles (such as a child, animal, pram or bicycle, etc.) or small, narrow objects such as stones or posts in your path when manoeuvring. |
Adjusting the parking distance control volume
Depending on the vehicle, certain settings can be adjusted from the touchscreen 1. Please see the equipment instructions for further information.
Deactivating the system
Press switch 2 to deactivate the system.
The indicator light built into the switch lights up to remind you that the system is deactivated.
Pressing the switch again will reactivate the system and switch off the indicator light.
Depending on the vehicle, you can deactivate the parking distance control from the touch-screen. Please see the equipment instructions for further information.
Operating faults
Depending on the vehicle, when the
system detects an operating fault, the
message “check parking distance control”
appears on the instrument panel,
accompanied by the warning light
and a beep lasting approximately
5 seconds. Please contact an
authorised dealer.
| An impact to the underside
of the vehicle while
manoeuvring (e.g.: striking
a post, raised kerb or
other street furniture) may result in
damage to the vehicle (e.g.: deformation
of an axle). To avoid any risk of accident, have your vehicle checked by an approved Dealer. |
READ NEXT:
Reversing camera
Operation
Moving into reverse gear, the 1 camera
(located on the tailgate on five-seater
versions or near the number plate lights
on estate versions) provides a view of
the area behind the ve
Automatic gearbox
Selector lever 1
P: park
R: reverse
N: Neutral
D: automatic mode
M: manual mode
+: upper gear
–: lower gear
4: displays the gear engaged in manual
mode.
Note: Press the button 2 to go
Your comfort
The Renault Clio IV (2014-2019) is designed with your comfort in mind. It features a well-crafted interior with quality materials and thoughtful ergonomics. The seats offer excellent support and adjus
SEE MORE:
High pressure pipe: Check
K9K
WARNING
After any operation, check that there are no diesel
fuel leaks
Reprime the diesel circuit using the priming pump.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the engine protector.
Disconnect the inlet air pressure sensor (1)
Remove
Tyre pressure loss warning
If fitted on the vehicle this system warns
the driver of pressure loss in one or
several tyres.
Operating principle
Each wheel (except for the emergency
spare wheel) has a sensor in the inflation
valve which periodically measures
the tyre pressure while driving.
Warning light 1 comes o
