Renault Clio: Luggage compartment cover: estate version
Renault Clio IV (2014-2019) Owners Manual / Your comfort / Luggage compartment cover: estate version
To remove the flexible section of the luggage compartment cover 1
Pull handle 2 gently to release the pins from their mounting points located on each side of the luggage boot.
Guide the luggage cover onto the roller.
Removing the luggage compartment cover
Using the handle 2, push the luggage cover to the right (movement A) and lift the left-hand side (movement B) in the inertia reel.
To refit the luggage cover, insert the right-hand side, then push it to the right (movement A) and lower the left-hand side of the inertia reel into its housing.
Luggage compartment cover storage 1
Lift the mobile floor (please refer to the information on “Boot storage space and fittings” in section 3).
Store the luggage compartment cover by inserting it, one side at a time.
Replace the mobile floor.
| Do not place any objects, especially heavy or solid objects on the luggage compartment cover. These may pose a risk to the vehicle occupants if the driver has to brake suddenly or if the vehicle is involved in an accident. |
READ NEXT:
Boot storage
Mobile floor
When fitted to the vehicle, it can be
used to make loading easier.
Note: if you need to access the ISOFIX
ring and/or the net ring at the bottom of
the boot, open flap 3.
Transporting objects in the boot
Always position the objects transported
so that the largest surface is against:
The rear bench seatback for normal
loads (example A).
The front seatbacks with the rear
seatbacks
SEE MORE:
Fuel flow: Check
D4F or K4J or K4M or M4R
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operation.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this operation.
WARNING
To avoid any corrosion or da
Solenoid valve assembly pressure sensor: Removal - Refitting
K9K, and JA5
REMOVAL
REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydrauli
