Renault Clio: Windscreen pillar trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION

- Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the top of the pillar trim at (2).

- remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION

- Check the condition of the clips (3).
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit the trim starting from the bottom.
III - FINAL OPERATION.

Side roof rail rear trim: Removal - Refitting
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the rear roof drip moulding lining.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Refit the rear roof drip moulding lining.
READ NEXT:
C85
REMOVAL
REMOVAL PREPARATION OPERATION
Remove:
the complete rear bench seat,
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCE
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
SEE MORE:
LEFT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Disconnect the battery (see Battery: Removal - Refitting).
Fit a pedal press on the brake pedal.
K4J or K4M or K9K
Remove the battery (see Battery: Removal - Refit
A wheel size larger than 15” cannot
be installed under the vehicle.
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its own, unwind it again as follows:
pull the handle to unwind the cable;
press the button located u
© 2016-2025 Copyright Renault Clio Owners Club
