Renault Clio: Door mirror: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove:
- the sealing foam (2),
- the bolts (3)
- the door mirror.
- Disconnect the supply connectors (depending on
equipment level).
SCHOOL VEHICLE


- Remove the bolts (5).
- Remove the door mirror.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED

- Connect the supply connector (depending on equipment
level).
- Refit:
- the door mirror,
- the bolts (6),
- the sealing foam.
SCHOOL VEHICLE
- Position the door mirror.
- Refit the door mirror bolts.
- Clip the casing in place.
II - FINAL OPERATION

- Clip the trim piece in place (7).
Door mirror casing: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the door mirror glass (see 56A, Exterior
equipment, Door mirror glass: Removal - Refitting, 56A-16).
II - REMOVAL OPERATION FOR PART
CONCERNED

- Unclip the clips (1).
- Fold in the door mirror.

- Unclip the door mirror casing.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Reclip the door mirror casing in position.
II - FINAL OPERATION
- Refit the door mirror glass (see 56A, Exterior
equipment, Door mirror glass: Removal - Refitting, 56A-16).
SCHOOL VEHICLE
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the door mirror glass (see 56A, Exterior
equipment, Door mirror glass: Removal - Refitting, 56A-16).


- Remove the bolts (2).
- Remove the door mirror.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip clips (3).
- Fold in the door mirror.

- Unclip the door mirror casing.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Clip on the door mirror casing.
II - FINAL OPERATION

- Offer up the door mirror.
- Refit the bolts (4).
- Clip on the casing
- Refit the door mirror glass (see 56A, Exterior
equipment, Door mirror glass: Removal - Refitting, 56A-16).
Door mirror glass: Removal - Refitting

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the door mirror glass using the (Car. 1363).
- Disconnect the supply connectors (depending on
the equipment level).
REFITTING
REFITTING PREPARATION OPERATION
- Connect the supply connectors (depending on the
equipment level).
- Clip the door mirror glass in position.
READ NEXT:
Note:
Once removed, the side decorative strips cannot
be refitted and must be replaced each time.
REMOVAL
I - REMOVAL PREPARATION OPERATION
1 - Front side door
Remove:
the front side door trim (se
EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the bolts (1).
Detach the decorative strip (2).
Note:
Replace the decorative strip (2) ever
SEE MORE:
K9K, and JA5
REMOVAL
REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydrauli
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
© 2016-2025 Copyright Renault Clio Owners Club
