Renault Clio: Drive plate: Removal -
Refitting
K4M, and DP0

REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the gearbox (see Automatic gearbox: Removal - Refitting).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Set up the (Mot. 582-01) (2).
- Remove:
- the bolts (2),
- the drive plate,
- tool (Mot. 582-01).
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check that the drive plate is not damaged (run-out
tolerance of 0.2 mm on the outer diameter).
II - REFITTING OPERATION FOR PART
CONCERNED
- Fit the drive plate, ensuring it is correctly positioned
in relation to the centring pins.
- Apply LOCTITE FRENBLOC to the bolt threads.
- Tighten the bolts on the drive plate.
- Torque and angle tighten the drive plate bolts (55
Nm + 50
READ NEXT:
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid val
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
SEE MORE:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the air filter box (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, 12A-17),
the intake distributor (see 12A, Fuel mixture, Inlet
distributor:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Remove the engine undertray.
Cut the exhaust pipe (see ) and (see 19B, Exhaust, Exhaust: Precautions
for the repair, 19B- 19).
II - OPERATION
© 2016-2025 Copyright Renault Clio Owners Club
