Renault Clio: Luggage compartment cover: estate version
Renault Clio IV (2014-2019) Owners Manual / Your comfort / Luggage compartment cover: estate version
To remove the flexible section of the luggage compartment cover 1
Pull handle 2 gently to release the pins from their mounting points located on each side of the luggage boot.
Guide the luggage cover onto the roller.
Removing the luggage compartment cover
Using the handle 2, push the luggage cover to the right (movement A) and lift the left-hand side (movement B) in the inertia reel.
To refit the luggage cover, insert the right-hand side, then push it to the right (movement A) and lower the left-hand side of the inertia reel into its housing.
Luggage compartment cover storage 1
Lift the mobile floor (please refer to the information on “Boot storage space and fittings” in section 3).
Store the luggage compartment cover by inserting it, one side at a time.
Replace the mobile floor.
| Do not place any objects, especially heavy or solid objects on the luggage compartment cover. These may pose a risk to the vehicle occupants if the driver has to brake suddenly or if the vehicle is involved in an accident. |
READ NEXT:
Boot storage
Mobile floor
When fitted to the vehicle, it can be
used to make loading easier.
Note: if you need to access the ISOFIX
ring and/or the net ring at the bottom of
the boot, open flap 3.
Transporting objects in the boot
Always position the objects transported
so that the largest surface is against:
The rear bench seatback for normal
loads (example A).
The front seatbacks with the rear
seatbacks
SEE MORE:
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCERNED
Unclip the B-pillar lower trim at (2).
Remove the B-pillar lower trim.
Unclip bolt c
Driveshaft: Precautions for the repair
DP0 or JH3 or JR5 or TL4
WARNING
A gearbox oil leak at the driveshaft may destroy it.
WARNING
Always replace seals whenever the driveshaft is
removed.
WARNING
Grease the base of the bearing using BR 2 +
grease to prevent the bearing from sticking.
Make sure that the O-ring is correctly positioned i
