Renault Clio: Rear fog lights: Removal - Refitting

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1

- Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- Move the rear fog light using the tool (Car. 1363) as a lever at (2).
- Disconnect the rear fog light connector.
- Remove the rear fog light.
REFITTING
I - REFITTING PREPARATION OPERATION
K85, and DOCUMENTATION PHASE 1

- If the indicator light bulb needs replacing, remove:
- the bulb holder (3) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- If the indicator light bulb needs replacing, remove:
- the bulb holder (4) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
- When replacing a bulb, use an approved bulb.
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the bulb on the bulb holder,
- the bulb holder by turning it forty-five degrees
clockwise.
- Connect the rear fog light connector.
- Clip the fog light onto the rear bumper.
Number plate light: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the licence plate light using a flat-blade
screwdriver.
- Disconnect the connector.

- Unclip the light at (1) to gain access to the bulb.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- When replacing a bulb, use an approved bulb.

- Connect the connector.
- Refit the light.
READ NEXT:
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
Fuses: List and location of components
Passenger compartment fuse and
relay box
Consumer cut-out fuse
Additional relay/fuse box
Battery protection fuses
Protection and switching unit
Power sup
SEE MORE:
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
Note:
Removal of the ESP or ABS computer is allowed.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove the entire hydraulic unit (see Hydraulic brake unit: Removal -
Refitting).
II - OP
© 2016-2025 Copyright Renault Clio Owners Club
