Renault Clio: Rear screen: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the tailgate trim (see Tailgate trim: Removal - Refitting)
(73A, Non-side opening elements trim),
- the rear screen wiper arm (see Rear screen wiper
arm: Removal - Refitting) (85A, Washing - Wiping),
- the rear screen wiper motor (see Rear screen wiper
motor: Removal - Refitting) (85A, Washing -
Wiping).
B85 or C85 or S85
- Remove the high level brake light (see 3rd brake
light: Removal - Refitting) (81A, Rear lighting).
- Disconnect the de-icing connectors.
REAR SPOILER
- Remove the tailgate spoiler (see 56A, Exterior
equipment, Tailgate spoiler: Removal - Refitting, 56A-3).
K85

- Remove the side seals (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85

K85

- Protect the edges of the rear screen using masking
tape.
- Cut the cement bead (see Technical Note 560A).
REFITTING
I - REFITTING PREPARATION OPERATION
- parts always to be replaced: Rear screen adjusting
shim (50,04,12,03).
- Refit the rear screen wiper motor (see Rear screen
wiper motor: Removal - Refitting) (85A, Wiping -
Washing).
- For preparation and bonding (see Technical Note
560A).
II - REFITTING OPERATION FOR PART
CONCERNED
- Bond the rear screen (this operation requires two
people).
- Equal out the clearances and shut lines.
- Remove the tabs from the stops once the adhesive
has dried.
III - FINAL OPERATION
K85
- Refit the side seals (1).
REAR SPOILER
- Refit the tailgate spoiler (see 56A, Exterior equipment,
Tailgate spoiler: Removal - Refitting, 56A-3).
B85 or C85 or S85
- the high level brake light (see 3rd brake light: Removal
- Refitting) (81A, Rear lighting).
- Connect the de-icing connectors.
- Refit the rear screen wiper arm (see Rear screen
wiper arm: Removal - Refitting) (85A, Wiping -
Washing).
- Carry out a function test.
- Refit the tailgate trim (see Tailgate trim: Removal -
Refitting) (73A, Non-side opening elements trim).
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Protect the edges of the trim with masking tape.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Note:
Fixed side trims may be removed in one of two
ways, dep
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR392, 02, Lifting equipment).
Remove:
the lower bolts (1).
the front pa
SEE MORE:
Gear lever
Vehicles with manual gearbox: refer
to the grid on the gear lever knob 1.
Vehicles with automatic gearbox:
refer to the information on the
“Automatic gearbox” in Section 2.
Selecting reverse gear
The reversing lights will come on as
soon as reverse gear is selected wit
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle. These special notes are specified
i
© 2016-2025 Copyright Renault Clio Owners Club
