Renault Clio: Airbag and pretensioners: List and location of components
I - LISTS OF COMPONENTS
list of components
Driver and passenger front airbags (1).
C85 or S85
Anti-submarining airbags located in the base of the front seats (2).
B85 or K85
Front buckle pretensioners located on the outside of the seat (3).
FRONT SIDE AIRBAG
Front chest-level side airbag located in the backrest of the front seats (4).
Pyrotechnic front seat belt inertia reels (5).
B85 or C85 or K85
Pyrotechnic rear seat belt inertia reels (6).
FRONT SIDE + CURTAIN AIRBAG
Side curtain airbag. (7)
II - FRONTAL AIRBAGS
Driver's front airbag
Passenger frontal airbag (entry level)
Passenger frontal airbag (top of the range)
C85 or S85
Anti-submarining airbag
Airbag computer
III - LATERAL AIRBAGS
FRONT SIDE AIRBAG or FRONT SIDE + CURTAIN
AIRBAG
Frontal (thorax) side airbag
FRONT SIDE + CURTAIN AIRBAG
Curtain side airbag
Side impact sensor
IV - FRONT SEAT BELTS
B85 or K85
Adjustable upper mounting
C85 or S85
Adjustable upper mounting
C85 or S85
Lower mounting
Front pyrotechnic inertia reel
B85 or K85
Lap belt pretensioner
V - REAR SEAT BELT
B85 or C85 or K85
Rear pyrotechnic inertia reel
READ NEXT:
I - PRECAUTIONS FOR REPAIR
IMPORTANT
All operations on airbag and pretensioner systems
must be carried out by qualified trained personnel.
The airbags have a pyrotechnic gas generator, with
an ignit
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 88C, Air bag and Pretensioners, A
IMPORTANT
To avoid any accidents, make sure you are aware of
all risks associated with this operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
It is essential to lock the airbag computer
SEE MORE:
The following operating conditions:
driving for long periods when the low
fuel level warning light is lit;
using leaded petrol;
using fuel or lubrication additives
which are not approved.
Or operating faults such as:
faulty ignition system, running out of
fuel or disconnected sp
1/3 and 2/3 rear bench seat base trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lift up the rear bench seat base.
Remove the rear bench seat base at (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the retaining strips (2).
Remove the seat trim and foam.
© 2016-2025 Copyright Renault Clio Owners Club