Renault Clio: Engine - gearbox assembly:
Removal - Refitting
- K4M, and JH3 - K4J, and JH3 - K4M, and TL4
- K4M, and DP0
- K9K, and JH3 or JR5 - K9K, and 772, and TL4
- D4F, and 740 or 742 or 764
- M4R, and DP0
- F4R
- M4R, and TL4
- K9K, and JA5
- D4F, and JA3
- D4F, and 784 or 786
- K9K, and JH3 or JR5 or TL4
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the battery (see Battery: Removal - Refitt
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
IMPORTANT
During this operation, secure the
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
During this operation, secure the ve
SEE MORE:
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
REMOVAL
I - REMOVAL PREPARATION OPERATION
Raise the window fully.
Switch off the ignition.
Disconnect the battery
LEFT-HAND DRIVE
Control panel
Cabin filter
Rear air distribution duct
Recirculation control cable
Air distribution cable
Air mixing cable
Air distribution unit
Heater matrix
Fan assembly
Heating resistor relay
Heating resistors:
Blower control unit.
Front side air distribution duct
Fr
© 2016-2025 Copyright Renault Clio Owners Club
