Renault Clio: Access to towing points

Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tightening it using the wheelbrace or,
depending on the vehicle, the lever.
Only use the towing eye 3 and the
wheelbrace located under the luggage
compartment carpet in the tool kit
(please refer to the information under
“Tools” in Section 5).
Do not leave the tools unsecured
inside the vehicle as
they may come loose under
braking. |
READ NEXT:
The following advice will enable you to carry out quick, temporary repairs.
For safety reasons you should always contact
an approved Dealer as soon as possible.
Using the RENAULT card
The Renault Clio IV, produced from 2014 to 2019, offers a range of technical specifications that contribute to its performance and versatility. It is available with gasoline and diesel engine options,
The information shown on the vehicle
identification plate should be
quoted on all correspondence or
orders.
The presence and location of the information
depends on the vehicle.
Vehic
SEE MORE:
1/3 and 2/3 rear bench seat base trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lift up the rear bench seat base.
Remove the rear bench seat base at (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the retaining strips (2).
Remove the seat trim and foam.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
K9K, and 750
Undo the clip (1) from the intercooler outlet pipe.
Move the intercooler outlet air pipe to one side (2).
Remove the turbocharger outlet air pipe reta
© 2016-2025 Copyright Renault Clio Owners Club
