Renault Clio: Towing
Before towing, unlock the steering column: with the clutch depressed, engage first gear (lever in position N or R for vehicles with automatic gearboxes), insert the RENAULT card in the card reader, then press the engine start button for two seconds.
Reposition the lever to neutral (position N for vehicles fitted with an automatic gearbox).
The column is unlocked, the accessory functions are supplied: the vehicle lights can be used (indicators, brake lights etc.). At night the vehicle must have its lights on.
Once you have finished towing, press the engine start button twice (risk of running down the battery).
| Do not remove the RENAULT card from the reader when the vehicle is being towed. |
The speed specified by current legislation for towing must always be observed.
If your vehicle is the towing vehicle, do not exceed the maximum towing weight for your vehicle (refer to the information on “Weights” in Section 6).
READ NEXT:
Towing a vehicle with an automatic gearbox
With the engine switched off, the transmission
is no longer lubricated. It is
preferable to tow this type of vehicle on
a trailer or tow it with the front wheels
off the ground.
Under exception
Access to towing points
Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tight
Operating faults
The following advice will enable you to carry out quick, temporary repairs.
For safety reasons you should always contact
an approved Dealer as soon as possible.
Using the RENAULT card
SEE MORE:
Front shock absorber and spring: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A,
Speed limiter
The speed limiter function helps you
stay within the driving speed limit that
you choose, known as the limit speed.
Controls
Main “On/Off” switch.
Limit speed activation, storage and
increase switch (+).
Decreasing the limit speed (-).
Activation and recall of memorised
