Renault Clio: On-board computer: general information
On-board computer 1
Depending on the vehicle, this includes
the following functions:
Display selection keys 2 and 3
Scroll through the following information
upwards (key 2) or downwards (key 3)
by pressing briefly and successively
(the display depends on the vehicle
equipment and country).
- total mileage and trip mileage recorder;
- fuel used;
- average fuel consumption;
- current fuel consumption;
- estimated range;
- distance travelled;
- average speed;
- distance before service;
- service counter;
- oil change counter;
- Reset the tyre pressure
- Cruise control and speed limiter programmed
speed
- Clock and temperature
- Trip log, operating faults and information
message readout
Resetting the trip mileage
With “trip mileage recorder” selected on
the display, press button 2 or 3 until the
mileage recorder resets to zero.
Resetting the journey
parameters (reset button)
With one of the trip parameters selected
as the display, press and hold button 2
or 3 until the display resets
Interpreting some of the
values displayed after
resetting
The values showing average fuel consumption,
range and average speed
will become more stable and reliable
the further you travel after pressing the
reset button.
For the first few miles after pressing
the reset key you will notice that the
range increases as you travel. This
range takes into account the average
fuel consumption since the last time the
reset button was pressed. Therefore,
the average fuel consumption may decrease
when:
- the vehicle stops accelerating;
- the engine reaches its operating
temperature (if the engine was cold
when the reset key was pressed);
- when driving from an urban area
onto the open road.
Automatic resetting of the
journey parameters
Resetting occurs automatically when
the maximum value of any of the parameters is exceeded.
READ NEXT:
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND
COUNTRY
Examples of selections
Interpreting the display selected
a) Total mileage and trip
Information messages
These can help in the vehicle starting phase, or give information about a
selection or a driving status.
Examples of information messages are given in the following pages.
SEE MORE:
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
When replacing brake pads, be sure to replace the
pads on the opposite side.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the
IMPORTANT
Wear protective gloves during the operation.
WARNING
Never rotate the engine anti-clockwise (timing end).
WARNING
Do not run the engine without the accessories belt,
to avoid breaking the crankshaft accessories pulley.
PARTS AND CONSUMABLES FOR THE
REPAIR WORK
Parts always to be replace
© 2016-2025 Copyright Renault Clio Owners Club