Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Left-hand drive

The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY. Side air vent. Stalk for: direction indicator lights; exterior lights; front fog lights; rear fog lights. Instrument panel. Driver Airbag and horn location. Multimedia system voice control bu

 K9K, and 750 or 752 or 766 or 768

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the engine undertray, the radiator mounting cross member bolt on the right-hand side, the sub-frame tie-rod bolt on the left-hand side.

© 2016-2025 Copyright Renault Clio Owners Club