Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Front side door sliding window: Removal - Refitting

Note: If the window is broken, replace the sealing film (see Door sealing film: Removal - Refitting) (MR 393, 65A, Door sealing). REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the door trim (see Front side door trim: Removal - Refitting) (MR 393,72A, Side opening element trim), the int

 Manual gear control: Adjustment

TL4 ADJUSTMENT ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION 1 - Passenger compartment Shift the selector lever to third gear. Fit a shim (1) (6 mm between the locking ring and reverse gear interlock on the selector lever. Use a strap (2) to immobilise the lever against the shim

© 2016-2025 Copyright Renault Clio Owners Club