Renault Clio: Passenger compartment temperature sensor: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Unclip the lower casing (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
- Disconnect the passenger compartment temperature sensor connector (2).
- Remove:
- the passenger compartment temperature sensor
bolts located inside the lower cover,
- the passenger compartment temperature sensor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the passenger compartment temperature sensor,
- the passenger compartment temperature sensor
bolts located inside the lower cover.
- Connect the passenger compartment temperature sensor connector (3).
II - FINAL OPERATION.
- Clip on:
- the lower cowling
- the upper cover.
Exterior air temperature sensor: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the door mirror glass (see Door mirror glass: Removal - Refitting),
- the door mirror casing (see Door mirror casing: Removal -
Refitting).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
- Unclip the exterior temperature sensor using a flat-blade
screwdriver.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Replace the exterior temperature sensor (see Technical
Note 6015A, Electrical wiring repair, 88A,
Wiring).
- Clip on the exterior temperature sensor.
II - FINAL OPERATION.
- Refit:
- the door mirror glass (see Door mirror glass: Removal - Refitting),
- the door mirror casing (see Door mirror casing: Removal -
Refitting).
Solar radiation sensor: Removal - Refitting
CLIMATE CONTROL
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Unclip the display mounting using tool (Car. 1597).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
- Remove the solar radiation sensor (1) from underneath
the dashboard.
- Disconnect the solar radiation sensor.
- Remove the solar radiation sensor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Connect the solar radiation sensor.
- Refit the solar radiation sensor (2).
II - FINAL OPERATION.
- Clip on the display mounting.
READ NEXT:
AIR CONDITIONING or CLIMATE CONTROL
I - SAFETY
IMPORTANT
The following must be worn when handling refrigerant:
gloves,
protective goggles (with side shields if possible).
In the event of refrigera
AIR CONDITIONING or CLIMATE CONTROL
Equipment required
Dual-sensor temperature measuring device
Note:
When performing RENAULT maintenance, check
the air conditioning system at the end of the vehicle's
SEE MORE:
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the door trim (see Rear side door trim:
Removal - Refitting) (MR 393, 72A, Side opening
element trim).
Unclip the access blanking cover at the locking bolt
of the dummy lock.
Loosen the locking bolt completely without removing
i
Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tightening it using the wheelbrace or,
depending on the vehicle, the lever.
Only use the towing eye 3
© 2016-2024 Copyright Renault Clio Owners Club