Renault Clio: Top And Front Of Engine

READ NEXT:

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

 Crankshaft accessories pulley: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the fron

SEE MORE:

 B-pillar trim: Removal - Refitting

B85 REMOVAL I - REMOVAL PREPARATION OPERATION Move the seats fully forward. Partially remove the frame seals (1). Partially unclip the front and rear door sill trims. II - REMOVAL OF PART CONCERNED Unclip the B-pillar lower trim at (2). Remove the B-pillar lower trim. Unclip bolt c

 Track rod: Removal - Refitting

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see Steering: Precautions for the repair). REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipme

© 2016-2025 Copyright Renault Clio Owners Club