Renault Clio: Mechanical Component Controls
- Manual gear control: Adjustment
- Master cylinder: Removal - Refitting
- Master cylinder - front right-hand calliper brake pipe: Removal - Refitting
- Master cylinder - front left-hand calliper brake pipe: Removal - Refitting
- Master cylinder - underbody union brake pipe: Removal - Refitting
- Brake servo non-return valve: Removal - Refitting
- Brake servo: Removal - Refitting
- Vacuum pump: Removal - Refitting
- Accelerator pedal: Removal - Refitting
- Brake pedal: Removal - Refitting
- Brake pedal switch: Removal - Refitting
- Brake compensator: Removal - Refitting
- Brake compensator: Check
- Parking brake lever: Removal - Refitting
- Clutch control: List and location of components
- Clutch pedal switch: Removal - Refitting
- Clutch circuit: Bleed
- Clutch master cylinder: Removal - Refitting
- Clutch circuit: Removal - Refitting
- Gear control: List and location of components
- Parking brake cables: Removal - Refitting
- Brake servo: Check
READ NEXT:
Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
Shift the selector lever to third gear.
Fit a shim (1) (6 mm between the locking ring and
rever
Master cylinder: Removal - Refitting
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
Master cylinder - front right-hand calliper brake pipe: Removal - Refitting
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
Air flowmeter: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Loosen the clip (1) between the air duct and the air
flowmeter.
Disconnect the air flowmeter connector.
Unfasten the air duct and remove it.
Disconnect the air flowmeter connector.
II
Flow actuator: Removal - Refitting
K9K, and 750 or 752 or 766 or 768
IMPORTANT
Before carrying out any work on the injection system,
check using the Diagnostic tool :
that the injector rail is not under pressure,
that the fuel temperature is not too high.
It is essential to respect the safety and cleanliness
advice whenever work
© 2016-2025 Copyright Renault Clio Owners Club
