Renault Clio: Mechanical Component Controls

Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls

READ NEXT:

 Manual gear control: Adjustment

TL4 ADJUSTMENT ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION 1 - Passenger compartment Shift the selector lever to third gear. Fit a shim (1) (6 mm between the locking ring and rever

 Master cylinder: Removal - Refitting

F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE WARNING Prepare for brake fluid outflow, to prevent damage to the mechanical parts and bodywork around the braking system. REMOVAL I - REMOVAL PRE

 Master cylinder - front right-hand calliper brake pipe: Removal - Refitting

LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equi

SEE MORE:

 Structural bodywork documentation: Use

B85 or C85 I - CLASSIFYING INFORMATION This information is classified in two complementary documents: 1 - Vehicle structure bodywork repair procedures (MR of the vehicle concerned) This document comprises two sections: a - Section 0: This section does not contain repair methods, it only contains des

 Rear drum bearing: Removal - Refitting

Using a dial gauge connected to the drum, check that the end float is greater than 0.03 mm. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Remove: the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35

© 2016-2025 Copyright Renault Clio Owners Club